Chemical Dispenser Assembly - Maytag Commercial MYR20 Service Manual

CHeMiCaL DiSpenSer aSSeMBLY

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. The chemical dispenser assembly has two
lids covering four dispenser openings.
2. Open the left lid to access the prewash
dispenser on the left, and the detergent
dispenser for the main wash on the right.
Prewash Detergent
Dispenser Dispenser
3. Open the right lid to access the bleach
dispenser on the left, and the fabric softener
dispenser on the right.
Bleach
Dispenser
4. A cap is provided, to cover the prewash
5. To remove the chemical dispenser, mark
6. Use a 7mm nut driver, Phillips, or Flat blade
7. Pull the hoses with a twisting motion
8. Slide the hose clamps down the hoses.
9. Loosen the hose clamp on the dispenser
10. Grasp the hose, twist and slide it off the
Fabric
Softener
4-3
dispenser, if prewash is not desired.
Prewash
Cap
the hoses for proper reassembly.
screwdriver to loosen the hose clamps
securing the water inlet hoses to the back of
the chemical dispenser assembly.
to remove the hoses from the chemical
dispenser.
outlet hose.
Dispenser
Outlet Hose
outlet.