Table of Contents
Advertisement
Installation
Connect Gas Supply
The gas supply inlet connection is a 1/2" NPT female.
Gas shut-off valve supplied on the end of stainless steel
fl exible connector. Flex connector is located on the left
hand rear corner of the appliance.
X
X
Use only new black iron or steel pipes, CSST, or copper
tubing if acceptable—check local codes. Note that
in USA, copper tubing must be internally tinned for
protection against sulfur compounds.
The burner module and gas train on this appliance may
be removed as a unit for servicing. The fl ex pipe supplied
with the unit provides a union for removal of the module.
Unions in gas lines should be of ground joint type.
The gas supply line must be sized and installed to
provide a supply of gas suffi cient to meet the maximum
demand of the appliance without undue loss of pressure.
Sealant used must be resistant to the action of all gas
constituents including LP gas. Sealant should be applied
lightly to male threads to ensure excess sealant does not
enter gas lines.
Pressure test the supply line for leaks.
The appliance and its individual shut-off valve must be
disconnected from the gas supply piping system during
any pressure testing of that system at test pressures in
excess of 1/2 psig (3.5 kPa).
The appliance must be isolated from the gas supply
piping system by closing its equipment shut-off valve
during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2 psi (3.5
kPa).
Failure to either disconnect or isolate the appliance
during pressure testing may result in regulator or valve
damages and void the warranty. Consult your dealer in
case of damages.
Gas Supply
1/2" NPT
female
Shut-off valve
supplied with
appliance
34" (864 mm)
fl ex pipe
supplied with
appliance
Control
Valve
Manifold
Pressure
Adjustment
behind
Plastic Cap
Valve Assembly
17
Advertisement
Table of Contents
