Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI Reference Manual page 233

Field
General
Connection
Interface Type
Trunk Signaling
Signaling Type
PCM Coding
Terminal Endpoint
Identifier
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Definition
Adit 3500:
Connections are T1 #1 through T1 #4. Select the checkbox for the T1
to apply the trunk settings to. Note: A red
available.
Adit MSR:
Connections are LCC #1 through LCC #8. Select the checkbox for the
LCC to apply the trunk settings to. Note: A red
LCC is not available.
Note: For the Adit MSR, when you select an LCC and apply it to the
trunk, the cross-connect status is displayed below the link number.
The status indications are:
No cross-connect - No cross-connect has been made for the selected
link.
Cross-connected to x - A cross-connect with compatible protocol
has been made. (x is the name of the cross-connected entity on the
controller. For example, a:1:1-24.)
Incompatible CAS/PRI Protocol on x - There is an incompatibility
in signaling protocol or link selection between the controller and
MSR card. (x is defined as above.)
Note: When you select the connection's name, the Channel
Configuration appears. See the Channel Configuration on page 6-30.
Displays the interface type (Network).
Sets the signaling type of the trunk.
PRI - Primary Rate Interface
CAS - Channel Associated Signaling
Sets the signaling type protocol on the trunk. Note: Hunt sequence of
the PRI is a Round-Robin type, and is not configurable.
If PRI is selected above:
PRI-ni2 - The CCITT National ISDN 2 PRI standard.
PRI-4ess - The class 4 US AT&T proprietary version of ISDN.
PRI-5ess - The class 5 ISDN central office circuit switching
system developed by AT&T.
PRI-dms100 - Digital central office switch (number 100) from
Northern Telecom.
If CAS is selected above:
EM Wink Start - E&M Wink Start.
EM Immediate Start - E&M Immediate Start.
EM Delay Wink Start - E&M Delay Wink Start.
Displays the defined Pulse Code Modulation.
Displays the Terminal Endpoint Identifier for the trunk.
Voice over IP
Trunk Settings
X indicates that the T1 is not
X indicates that the
6-27