Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI Reference Manual page 134

Network Connections
Connections that Require Configuration
Field
DNS Static Entries
Obtain DNS Server
Address Automatically
Use the Following DNS
Server Address
Routing
Routing Mode
SIP ALG
Device Metric
Default Route
Routing Protocol
Internet Connection
Firewall
Additional IP Addresses
3-24
Definition (Continued)
(This name is a link to the Advanced/DNS Static Entries window.)
Sets the interface to obtain a DNS Server address.
Sets the DNS Server Address.
Primary DNS Server - Enter the specific DNS server address to use.
Secondary DNS Server - Enter a secondary DNS server address to
use.
Displays the current routing mode.
Route - Routing is used if public is visible on both sides.
NAPT - NAPT is used if doing private IPs on the Ethernet side or if
you want to hide specific publics on the internal side.
This field allows the customer to turn off the SIP ALG on external
interfaces.
Checked - the SIP ALG will be switched off.
Unchecked - the SIP ALG will not work.
Value of Metric of IP network on this interface in the Routing Table.
Range is 0-255, with a default of 20.
Check to enable default route.
None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a
link below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 -
Multicast
Note: This name is a link to the Security window
Enables/Disables Firewall for this device.
Opens a window to add an additional IP address with subnet mask.
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI