Table of Contents
Advertisement
Network Connections
Preconfigured Connections
Configuring a T1 (1-4)
The Configure T1 n (1-4) window displays all of the T1 configuration parameters and the default
settings for each. To configure a T1, select the Settings button, the Configuration window will
display. Field definitions for this window are as follows:
Field
General
Device Name
Status
Schedule Availability
Connection Type
T1 Configuration
Circuit Identifier
Framing Type
Line Coding
Loop Code Detection
Facilities Data Link
Line Build Out
Apply loopback to DS1
interface
Idle Pattern
3-14
Definition
Displays the device name (t1-n).
Displays the current status.
Defines when the T1 is available. An additional window will open
to create a Schedule Availability rule, which will then display in the
pulldown selection. Default is Always.
Displays connection type (T1).
Display/edit the Circuit ID, default is Adit 3000.
ESF - To Extended Superframe (ESF) framing.
D4 - To D4 Superframe (SF) framing.
Alternate Mark Inversion line coding (AMI)
Binary 8 Zero Substitution line coding (B8ZS) - Default
Enable detection of CSU loop codes
Enable detection of NIU loop codes
Off - Default
None - Disable FDL output messages. Default.
T1.403 FDL - Enable T1.403 FDL performance messages.
fdlPMMsg - Enable FDL Performance Monitoring messages.
Sets the DS1 Line Build Out (LBO).
DSX-1 equalization for 0-133ft - Default
DSX-1 equalization for 133-266ft
DSX-1 equalization for 266-399ft
DSX-1 equalization for 399-533ft
DSX-1 equalization for 533-655ft
CSU attenuation for LBO of -7.5dB
CSU attenuation for LBO of -15dB
CSU attenuation for LBO of -22.5dB
None (loopback disabled) - Disable loopback. Default
Line loopback enabled - Apply line loopback.
Payload loopback enabled - Apply payload loopback.
A hexadecimal number with a range from 0x00 to 0xff. This
number must be preceeded by 0x.
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Advertisement
Table of Contents
