Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI Reference Manual page 117

Carrier access msr/adit 3k gui multi-service router (msr) card gui reference manual
Table of Contents

Advertisement

Field
IP Address Distribution
window.)
Disabled
DHCP Server
DHCP Relay
DHCP Options
Routing
Routing Mode
Device Metric
Default Route
Proxy ARP -
Ethernet ARP Proxy
Routing Protocol
Internet Connection
Firewall
Allow Unrestricted
Administration
Additional IP
Addresses
NOTE:
For a manually specified network mode (Internet Protocol: Use the following IP address), the
default route does not get installed until both the Default Route checkbox is enabled AND the user has
entered a valid non-0.0.0.0 Gateway IP in the Default Gateway field.
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Definition (Continued)
(This name is a link to the Advanced/IP Address Distribution (DHCP)
Disables this feature.
Configures DHCP Server.
Start IP Address - Client address pool starting address
End IP Address - Client address pool ending address
Subnet Mask - Subnet mask of the Start/End IP address listed above.
WINS Server IP Address - Windows Internet Name
Service Server IP address.
Lease Time In Minutes - lease during the DHCP
server applies to the client assignments.
Provide Host Name if Not Specified by Client - Select to enable.
New IP Address - The address of the DHCP Relay Server.
Opens a window that configures the DHCP options per RFC 2132. See
Configuring DHCP Options on page 3-8.
(This name is a link to the Advanced/Routing window)
Displays the current routing mode.
Value of Metric of IP network on this interface in Routing Table. Range is 0-
255.
Check to enable default route.
Check to enable Proxy ARP.
None - Disable the routing protocol on this interface.
OSPF - Set the routing protocol to OSPF on this interface. There is a link
below the option to configure OSPF.
RIP - Set the routing protocol to RIP on this interface.
Listen to RIP Messages - None, RIPv1, RIPv2, RIPv1/2
Send RIP Messages - None, RIPv1, RIPv2 - Broadcast, RIPv2 - Multicast
Note: This name is a link to the Security window.
Enables/Disables Firewall for this device.
Note: This name is a link to the Security window.
Enables/disables unrestricted administration.
New IP Address - Opens a window to assign an additional IP address to this
device.
Network Connections
Preconfigured Connections
3-7

Advertisement

Table of Contents
loading

Table of Contents

Save PDF