Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI Reference Manual page 133

The following are field definitions for the Configure Serial 1 window:
Field
General
Device Name
Status
Schedule Availability
Network
Connection Type
MTU
Underlying Device
PPP -
On Demand
Time Between
Reconnect Attempt
Restart Timer
PPP Authentication
Login User Name
Login Password
PPP Encryption
Internet Protocol
Unnumbered
Obtain an IP Address
Automatically
Use the Following IP
Address
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Definition
Displays the device name.
Displays the current status.
Defines when the WAN is available. The default is Always. To create
a Schedule Availability rule, click New.
Defines the type of network:
WAN - Wide Area Network (Default).
LAN - Local Area Network
DMZ - Demilitarized Zone
Displays the connection type:
Adit 3000: PPPoT1
Adit MSR: Serial
Maximum Transmission Unit. Sets the largest packet size (bytes) the
network will transmit.
Automatic at 1500
Manual at a range of 576 to 1500.
Displays the device/connection required for this interface:
Adit 3000: Displays the T1 in this connection. This is a link to the
High Speed Serial Configuration window. See Underlying Device -
High Speed Serial Configuration (Adit 3000 Only) on page 3-25.
Adit MSR: Displays the LCC in this connection.
Note: These fields do not display when The Internet Protocol field is set to "unnumbered"
Attempts to connect only when packets are sent.
Sets the interval of time between reconnect attempts.
Range is 0 - 99999 seconds. Default is 30 seconds.
Range is 1 - 65535 seconds. Default is 3 seconds.
Enter Login User Name, with a maximum of 100 characters.
Enter login password.
Select to enable support of the following:
Support Unencrypted Password (PAP)
Support Challenge Handshake Authentication (CHAP)
Support Microsoft CHAP (MS-CHAP)
Support Microsoft CHAP Version 2 (MS-CHAPv2)
The following PPP encryption can be enabled by checking the boxes:
Require Encryption (Disconnect if server declines)
Support Encryption (40 bit keys)
Support Maximum Strength Encryption (128 bit keys)
Treat this as an un-numbered interface per RFC 1812. Default.
Sets the WAN to use DHCP to obtain an IP address.
Override Subnet Mask - Set mask, override any previous setting.
IP Address - Sets the IP Address
Override Subnet Mask - Set mask, override any previous setting.
Network Connections
Connections that Require Configuration
3-23