Carrier Access Multi-Service Router (MSR) Card MSR/Adit 3K GUI Reference Manual page 223

Carrier access msr/adit 3k gui multi-service router (msr) card gui reference manual
Table of Contents

Advertisement

Field
Identification
Begin Line Number
End Line Number
User ID
Cross Connect Name
Description
Packet Processing
Codec Pref1
Codec Pref2
Codec Pref3
Fax Mode
Modem/SuperG3 Fax
Mode
Silence Suppression
Jitter Buffer
Voice Processing
Transmit Gain
Receive Gain
Impedance
Echo Cancellation
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) GUI
Definition
Displays the line number that was selected to edit.
Specifying a line number here allows a user to define a range to apply
the settings to. Settings will be applied to all the lines between "begin
line number" and "end line number".
Display/Edit the current User ID. Note: A maximum of 20 characters
is allowed.
This field appears for the MSR only.
Display/Edit the line description. Use the display name for Caller ID.
Codec preferences are used to establish the codec list offered during
media negotiation. Pref1 is the first codec, followed by pref2 and
pref3.
Select the first codec preference.
Select the second codec preference.
Select the third codec preference.
None - A Fax call would be treated as a normal voice call. Default.
Bypass - Causes the line to transmit in G.711 mode, with silence
suppression disabled, on detection of Fax tone.
None -
A Modem call would be treated as a normal voice call.
Default.
Bypass -
Causes the line to transmit in G.711 mode, with echo
cancellation and silence suppression disabled, on detection of
Modem tone.
Select to enable Silence suppression on the line.
Set Jitter Buffer from the pulldown menu.
Static -
Maintain a static average delay, through the jitter buffer.
Default.
Dynamic - Specify dynamic delay adjustment to minimize delay
through the jitter buffer.
Set transmit gain. Range -12 to +6.
Transmit direction is from the Adit towards FXS.
Set receive gain. Range -12 to +6.
Transmit direction is from the FXS towards the Adit.
Set the impedance from the pulldown menu.
Note: Not supported by the MSR. (Impedance is handled by the
Adit 600 controller or card.)
Select to enable Echo Cancellation on the lines.
Voice over IP
Phone Settings
6-17

Advertisement

Table of Contents
loading

Table of Contents

Save PDF