Connecting The Utility Software; Using The [Dv/Dd] Switch (For Only The Id-Rp1200Vd) - Icom ID-RP2010V Instruction Manual

3
INSTALLATION AND CONNECTION

■ Connecting the Utility software

Sets the transmit and receive frequency, repeater call sign and other function settings using the Utility for ID-RP3.
Ask your dealer for details of the utility.
Connect the repeater and the Windows PC that the Utility for ID-RP3 is installed in, as shown below.
To use the USB cable between the repeater and a PC, you must first install a USB driver.
Download the latest USB driver and installation guide on the Icom website.
https://www.icomjapan.com/support/
PC

■ Using the [DV/DD] switch (For only the ID-RP1200VD)

The usage of the ID-RP1200VD's antenna connector differs depending on the operation mode, as shown below.
L The mode selsction item of the Utility for ID-RP3 is disabled while operating in DD mode.
DV mode: RX
DD mode: Not used
ID-RP1200VD
USB cable (Supplied with the repeater)
DV mode: TX
DD mode: TX and RX
[DD]
[DV/DD]
[DV]
ID-RP2010V/ID-RP4010V
7
Type-B
Unused switch