Table of Contents
Advertisement
■ Precautions
R DANGER HIGH RF VOLTAGE! NEVER touch an
antenna or antenna connector while transmitting. This
could cause an electrical shock or burn.
R DANGER HIGH RF VOLTAGE! NEVER install
the antenna at any place that person easily touch
the antenna while transmitting. This could cause an
electrical shock or burn.
R WARNING! NEVER apply AC power to the
[DC13.8V] socket on the repeater rear panel. This
could cause a fire or damage the repeater.
R WARNING! NEVER apply more than 16 V DC to
the [DC13.8V] socket on the repeater rear panel. This
could cause a fire or damage the repeater.
R WARNING! NEVER remove the fuse holder on the
DC power cable. Excessive current caused by a short
could cause a fire or damage the repeater.
R WARNING! NEVER reverse the DC power cable
polarity. This could cause a fire or damage the
repeater.
R WARNING! NEVER let metal, wire or other objects
contact the inside of the repeater, or make incorrect
contact with connectors on the rear panel. This could
cause an electric shock or damage the repeater.
R WARNING! NEVER operate or touch the repeater
with wet hands. This could cause an electric shock or
damage to the repeater.
R WARNING! NEVER operate the repeater if
you notice an abnormal odor, sound or smoke.
Immediately turn OFF the power and/or remove
the DC power cable. Contact your Icom dealer or
distributor for advice.
R WARNING! NEVER put the repeater on an
unstable place where the repeater may suddenly
move or fall. This could cause an injury or damage the
repeater.
CAUTION: DO NOT expose the repeater to rain, snow
or any liquids. They could damage the repeater.
CAUTION: DO NOT use or leave the repeater in areas
with temperatures below –10°C (+14°F) or above
+50°C (+122°F) Be aware that temperatures can
exceed 80°C (+176°F), resulting in permanent damage
to the repeater if left there for extended periods.
CAUTION: DO NOT place or leave the repeater in
excessively dusty environments. This could damage
the repeater.
CAUTION: DO NOT use harsh solvents such as
benzine or alcohol when cleaning. This could damage
the repeater surfaces. If the surface becomes dusty or
dirty, wipe it clean with a soft, dry cloth.
CAUTION: DO NOT put anything on top of the
repeater. This will obstruct heat dissipation.
BE CAREFUL! The repeater rear panel will become
hot when continuously transmitting for long periods of
time.
NEVER leave the repeater in an insecure place to
avoid use by unauthorized persons.
Icom is not responsible for the destruction, damage
to, or performance of any Icom or non-Icom
equipment, if the malfunction is because of:
• Force majeure, including, but not limited to, fires,
earthquakes, storms, floods, lightning, or other
natural disasters, disturbances, riots, war, or
radioactive contamination.
• The use of Icom repeaters with any equipment
that is not manufactured or approved by Icom.
Icom and the Icom logo are registered trademarks
of Icom Incorporated (Japan) in Japan, the United
States, the United Kingdom, Germany, France,
Spain, Russia, Australia, New Zealand and/or other
countries.
AMBE+2 is a trademark and property of Digital Voice
Systems Inc.
All other products or brands are registered trademarks
or trademarks of their respective holders.
ii
Advertisement
Table of Contents
