D Receiver; Connectors; D [Dc 13.8 V]; D [Lan 1] - Icom ID-RP2010V Instruction Manual

6
INFORMATION
■ Specifications (Continued)

D Receiver

• Receive system:
• Sensitivity:
• Selectivity:
• Selectivity (ID-RP1200VD):
• Intermodulation:
• Receive spurious:
• Spurious & image rejection:
• Audio output power:
• AF output impedance:

■ Connectors

D [DC 13.8 V]

Accepts the regulated DC power of
13.8 V DC ±15% through the supplied
DC power cable.
RWARNING! NEVER reverse the
DC power cable polarity.

D [LAN 1]

Connects to a Gateway server when
operating in the Gateway repeater
mode.
About the LED indication:
1 LINK/ACT
• Lights when a cable is connected.
• Does not light when a cable is not
connected.
• Blinks while communicating.
2 SPEED
• Lights while communicating in
100BASE-TX.
• Does not light while communicating.
• Blinks while communicating in
10BASE-T, or not connected.
ID-RP2010V/ID-RP4010V
ID-RP1200VD
FM
DV
DD (ID-RP1200VD)
FM (BW: 15 kHz)
DV
FM (BW: 15 kHz)
FM (BW: 7 kHz)
DV
DD
ID-RP2010V/ID-RP4010V
ID-RP1200VD
ID-RP2010V/ID-RP4010V
ID-RP1200VD
1 2
15
RF direct sampling
Superheterodyne
–15 dBµV (0.18 μV) or less (At 12 dB SINAD)
–13 dBµV (0.22 μV) or less (At 1% BER (PN9))
4 dBµV (1.58 μV) or less (At 1% BER (PN9))
More than 12.0 kHz/–6 dB, 20 kHz or less/–60 dB
–50 dB or less (Channel spacing=12.5 kHz)
20 kHz or less/–50 dB
10 kHz or less/–50 dB
–40 dB or less (Channel spacing=12.5 kHz)
–40 dB or less (Channel spacing=300 kHz)
–60 dB or less
–50 dB or less
2 nW (–57 dBm) or less
More than 55 dB
More than 50 dB
More than 2.0 W (1 kHz, 10% distortion into an
8 Ω load)
8 Ω

D [LAN 2]

Connects to a Gateway server when
operating in the LTE mode.
L An optional LTE unit is required.
About the LED indication:
1 LINK/ACT
• Lights when a cable is connected.
• Does not light when a cable is not
connected.
• Blinks while communicating
2 SPEED
• Lights while communicating in
100BASE-TX.
• Does not light while communicating.
• Blinks while communicating in
10BASE-T, or not connected.

D [CONT I/O]

Connects to the LAN port of the ID-
RP2C using a supplied control cable,
when the repeater system is operating
as a gateway or assist repeater with
the ID-RP2C.
L Set [CONT I/O RPT] on the rear panel
to "CONT I/O," when using this port.
1 2