Table of Contents
Advertisement
■ Front panel
1
1 POWER SWITCH [POWER]
• Push to turn the repeater ON.
L Lights green when the repeater is ON.
• Hold down to turn the repeater OFF.
2 HIGH/LOW POWER SELECT SWITCH [H/L]
z Sets the output power to High (25 W) or Low (2.5 W).
(ID-RP2010V/ID-RP4010V)
z Sets the output power to High (10 W) or Low (1.0 W).
(ID-RP1200VD)
3 SD CARD SLOT [SD CARD] (p. 10)
Accepts an SD card. Used for firmware updates,
importing and exporting setting data and voice data.
4 TRANSMIT INDICATOR [TX]
Lights red while transmitting.
L Blinks when an error has occurred.
5 RECEIVE INDICATOR [RX]
Lights green while receiving.
L Blinks when the firmware is successfully updated.
NOTE: Both [TX] and [RX] blinks at the same time
when the repeater is reset to the default value.
6 ETHERNET CONNECTOR [LAN 1]
Connects to a Gateway server PC.
L If multiple repeaters are connected, and the ID-
RP1200VD operating in DD mode is included, connect
the gateway server to the ID-RP1200VD. The system
does not work if it is connected to other repeaters.
2
3
4 5
6
7
PANEL DESCRIPTION
8 9 10
7 RESET SWITCH
The switch used for special operation such as
resetting the repeater, and so on.
L Push using the tip of the pen.
L The switch is also used when updating the firmware.
8 LTE STATUS [STATUS]*
Indicates the LTE status.
L About the LED indication
• Lights while communicating.
• Blinks while registering to an LTE network.
• Slowly blinks when a communication failure occurs.
• Does not light when SIM cards are not inserted, or
the LTE connection setting is not applied.
9 LTE ANTENNA INDICATOR [ANT]*
Indicates the relative receive signal strength level.
L About the LED indication
• Lights when the signal strength is good.
• Blinks when the signal strength is poor.
• Does not light when out of service ,or the repeater
cannot connect to an LTE network.
10 ETHERNET CONNECTOR [LAN 2] *
Connects to a Gateway server PC when operating
in the LTE mode.
L If multiple repeaters are connected, and the ID-
RP1200VD operating in DD mode is included, connect
the gateway server to the ID-RP1200VD. The system
does not work if it is connected to other repeaters.
* 8, 9, and 10 are used only when an optional LTE unit is
installed.
2
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Advertisement
Table of Contents
