Chrysler DODGE D150 1993 Service Manual page 74

•
Fig. 8 Spacer Removal/Installation
Fig. 9 Wheel Bearing Lock Nut Removal
ASSEMBL Y/INSTALLA TION
(1) Add Wheel Bearing Grease lubricant (NLGI
Grade 2, E P or an equivalent lubricant) to the bear­
ings. Install a new needle bearing in the spindle with
Installer D-122 and Handle C-4171 (Fig. 14).
(2) Lubricate and install a new spindle seal with
Installer D-155 and Handle C-4171 (Fig. 15).
(3) Install the seal with lip facing the axle shaft
splines (Fig. 16). Lubricate the seal (Fig. 17) with
Wheel Bearing Grease lubricant (NLGI Grade 2, E P
or an equivalent lubricant).
FRONT SUSPENSION AND AXLE 2 - 21
LOCK WASHER INNER LOCK NUT
Fig. 10 Lock Washer Removal/Installation
Fig. 11 Spindle Removal
(4) Right side only: carefully install the axle shaft
through the knuckle into the axle housing. Ensure
the axle shaft splines are engaged with the differen­
tial side gears. Avoid damaging the differential
seals.
(5) Left side only: remove the shift motor housing
from axle. Position the shift collar on the intermedi­
ate axle shaft. Install the axle shaft, ensure the axle
shaft splines are engaged with the shift collar. In­
stall the shift motor (ensure the fork is engaged with
the shift collar) and tighten the bolts to 14 Nnn (10
ft. lbs.) torque.
(6) Install the spacer on the axle shaft end.
(7) Install the brake splash shield and spindle on
the steering knuckle. Install new nuts and tighten to
34-41 Nnn (25-35 ft. lbs.) torque (Fig. 18).