Specifying The Stakeout Point By Coordinates - Nikon DTM-302 Series Instruction Manual

4 Applications

Specifying the stakeout point by coordinates

To start a stakeout by coordinates, press
1.
XYZ
select in the Stakeout menu.
Enter the point name that you want to stake
2.
and press
[ENT]
You can also specify the point by code or
radius from the instrument.
If several points are found, they are displayed
in a list. Use [^]
list. Use [<] or
Highlight a point in the list and press
3.
The delta angle and the distance to the target
are shown.
Rotate the instrument until the dHA is close to
4.
0°00'00". Press
dHA Difference in horizontal angle to the
target point
HD Distance to the target point
Ask the rodman to adjust the target position.
5.
When the target is on the intended position,
the displayed errors become 0.000 m (or
0.000 ft).
dHA Difference in horizontal angle to the
target point
R/L Right/Left (Lateral error)
IN/OUT In/Out (Longitudinal error)
CUT/FIL Cut/Fill
76 Total Station DTM-302 Series Instruction Manual
.
or [v] to move up and down the
[>] to move up or down one page.
or .
[MSR1] [MSR2]
[2] or
.
[ENT]
40.1