Turning Off The Instrument - Nikon DTM-302 Series Instruction Manual

Turning off the instrument

To turn the instrument off, press
Then do one of the following:
Press ...
[ENT] again
Reset
the softkey
Sleep
the softkey
[ESC]
If you press the
Measurement Screen (BMS) appears without an open job.
Sleep mode
Sleep
If you press the
→
OFF screen, or enable the Power Save setting
(see Power saving, page 130), the instrument goes
into sleep mode.
When the instrument is in sleep mode, it wakes up
if any of the following occurs:
• You press a key
• The instrument receives a remote control command
• You rotate the alidade
• You tilt the telescope
[PWR]
To ...
turn off the instrument
reboot the program and re-start the instrument
put the instrument into power-saving mode
cancel the power-off process and return to the
previous screen
Reset
softkey, the software is rebooted and the Basic
softkey in the Press
Total Station DTM-302 Series Instruction Manual 25
and [ENT] .
[ENT]
Getting Started 3
30.1