Ha Reset And Angle Operations; Setting The Horizontal Angle To 0; Entering The Horizontal Angle; Recording A Foresight Point After Repeat Angle Measurement - Nikon DTM-302 Series Instruction Manual

4 Applications

HA Reset and Angle Operations

To open the Angle menu, press
To select a command from this menu, either press
the corresponding number key, or press
highlight the command and then press
F1/F2 is not supported by the DTM-332.

Setting the horizontal angle to 0

To reset the horizontal angle to 0, press
display returns to the Basic Measurement Screen (BMS).

Entering the horizontal angle

To display the HA Input screen, press
Input
in the Angle menu. Use the numeric keys
to enter the horizontal angle. Then press
To enter 123°45'50", type
The displayed value is rounded to the minimum angle increment.

Recording a foresight point after repeat angle measurement

To activate repeat angle measurement, press
1.
Rept.
[3] or select
HR=0
is displayed.
Sight the backsight and press
2.
Sight the foresight and press
3.
The horizontal angle is accumulated and the
value is held again.
To end repeat angle measurement, press
4.
56 Total Station DTM-302 Series Instruction Manual
[ANG] in the BMS.
[<]
[ENT]
[1]
[2]
[1] [2] [3] [.] [4] [5] [5] [0]
in the Angle menu.
[ENT] .
[ENT] .
or [>] to
.
0-Set
or select
or select
[ENT] .
.
[ESC] .
in the Angle menu. The
4.1
41.1
41.2
41.3