Settings; Angle - Nikon DTM-302 Series Instruction Manual

Settings

To display the Settings menu, press
Settings
on the MENU screen.
Use this menu to configure the initial job settings.
Some job settings, specified in the following
sections, cannot be changed once a job is
created. If any of these settings are changed while
a job is open, a confirmation screen appears,
asking you to create a new job with the new
settings, or to work with those settings without
recording any data. For more information, see
Settings, page 201.

Angle

To open the Angle menu, press
Angle
in the Settings menu.
VA zero
The VA zero job setting cannot be changed once a job is created.
Resolution
HA
The HA job setting cannot be changed once a job is created.
When this field is set to Azimuth, the horizontal angle (HA) that is displayed and
recorded is in Azimuth value. When this field is set to 0 to BS, HA is in HA zero to
BS value.
[1] or select
Zenith/Horizon/Compass
1"/5"/10" or 0.2 mgon/1 mgon/2 mgon
0 to BS/Azimuth
Total Station DTM-302 Series Instruction Manual 127
[2] or select
Menu Key 5
5.1
51.1