Programs; Recording Data - Nikon DTM-302 Series Instruction Manual

Programs

NO Stn Setup
You did not perform a station setup or BS check before entering the Programs
function.
To ...
go to the Stn Setup menu
return to the BMS
go to the Programs menu
C
Warning – Selecting
should only use the
coordinates and the current HA orientation are correct. Otherwise, records in
the Programs function may not be correct.
XY&Z coordinate are required
Three-dimensional coordinates are required in S-Plane function.
Press any key to return to the point input screen. Then enter a three-dimensional
point.

Recording Data

DATA FULL
The data storage is full.
Press any key to return to the Basic Measurement Screen (BMS). Then:
To ...
delete unnecessary data
delete jobs
DUPLICATE PT
The input PT you are trying to record already exists in the current job. An existing
coordinate record cannot be overwritten by measured data.
Press any key to return to the point input screen. Change PT.
Press ...
Stn Setup
[2] or select
[ESC]
Continue
[1] or select
Continue
does not resume the last ST record. You
Continue
option if you are sure that the previous ST
Go to ...
MENU > Data
MENU > Job
Total Station DTM-302 Series Instruction Manual 199
Error Messages 10
106.1
106.2
107.1
107.2
10.6
10.7