Scan adaptation
Scan connectors
The scan connectors must be placed in the correct position which correspond to the desired scanning configuration. To change
the scanning, it is necessary to lift up the protection plate on the top/back of the electric block.
Access to the scan connectors
1
Loosen the indicated bolts, 3 on each side and 2 on top.
2
Lift up the protection plate.
3
The connectors are located at the top/back of the electronic block.
image 4.3
Scan connectors
5976397 SPLIT PACK REALITY 909 09112001
3 blots on the left
Installation setup
3 blots on the right
2 blots on top
4 - 3