Installation set-up
Scan Adaptation
The scan switches must be placed in the correct position which corresponds to the desired scanning configuration.
To change the scanning, it is necessary to remove the projector top cover and to open the protection plate.
For opening the projector's top cover, see 'Access to controls'.
TURN OFF PROJECTOR AND UNPLUG THE POWER
CORD BEFORE CHANGING THE SCAN DIRECTION.
Getting access to the scan switches
open the top cover and remove it from the projector (see p.4-1);
loosen the 3 lock screws with a screwdriver by turning a quarter
counter clockwise;
remove the fixation screw nearby the fan.
lift up the metal cover plate and pivot it to the lens side.
take off the cover plate.
loosen the lock screw of the scan switches module plate.
pivot the scan switches module plate to the lenses.
4-2
WARNING !
Fixation screw
Lock screws
5975857 BARCOGRAPHICS 1208s 220197