Table of Contents
Advertisement
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
This procedure can only be done after power (mains) connection. So, first continue with the projector setup and the connections
and then return to this procedure.
1
Switch on the projector. The projector starts up on the last selected source.
2
Press ADJUST.
3
Highlight SERVICE by pushing the cursor key é or ê (menu 1).
4
Press ENTER, SERVICE MODE menu will be displayed. (menu 2)
5
Highlight PROJECTOR SET-UP by pushing the cursor key é or ê and press ENTER.
6
Push the cursor key é or ê to highlight IDENTIFICATIOn (menu 3).
7
Press ENTER to select.
The identification screen will be displayed (menu 4).
This screen gives the current information about the projector configuration in the line entitled CONFIG.
ADJUSTMENT MODE
Select a path from
below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
All projectors leave the factory set with a ceiling/front configuration.
5976397 SPLIT PACK REALITY 909 09112001
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
menu 3
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 3
Installation setup
REALITY 909
Proj. address : 001
Soft. Version : 2.11
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 1035895
menu 4
4 - 5
Advertisement
Table of Contents
