Table of Contents
Advertisement
Installation Set Up
Scan adaptation
The scanning can be switched by turning the Horizontal and Vertical scan connectors.
To change the scanning, it is necessary to open the projector top cover (see "Access to control").
To gain access to the connectors, the top frame has to be turned 90° to the back until it grips into its locks.
Therefore, the following the next procedure :
•
Remove the four screws, two on each side, that are fixing the heatsinks to the frame (image 1).
•
Remove three screws that are fixing the frame to the metal chassis.
•
Pivot the frame 90° to the back.
WARNING :
TURN OFF PROJECTOR AND UNPLUG THE POWER CORD BEFORE CHANGING THE SCAN DIRECTION.
Scan Inversion
A : Horizontal scan inversion
Three connectors are used, one for each horizontal deflection coil.
connectors are set in the same position.
B : Vertical scan inversion
Three connectors are used, one for each vertical deflection coil. When changing the vertical scan, ensure that all three connectors
are set in the same position.
Remarks : As per the factory setting, this photo is in Front / Ceilling position.
4-2 ____________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
It is possible that you have to pull strongly on the frame to open it.
See position of the connectors for the corresponding projector configuration.
See position of the connectors for the corresponding projector configuration.
Color of the wires is as follows :
R = Red, B = Blue, Y = Yellow, G = Green
When changing the horizontal scan, ensure that all three
Front / Table
Front / Ceiling
Horizontal scan inversion
B
R
B
B
R
B
B
R
B
Vertical scan inversion
G
Y
G
G
Y
G
G
Y
G
Rea
r / Ceiling
Rear / Table
B
R
R
R
R
B
R
R
R
B
R
R
Y
G
Y
G
Y
G
Y
G
Y
G
Y
G
B
B
B
Y
Y
Y
Advertisement
Table of Contents
