Source Connections; Input Locations - Barco R9040040 Instruction Manual

Hide thumbs Also See for R9040040:
Table of Contents

Advertisement

6

SOURCE CONNECTIONS

Input locations

Input facilities
The following source types can be connected to the inputs :
- Composite Video
- S-Video
(1)
- RGBS or RGsB
- RGB3S or RG3sB
- (R-Y)Y(B-Y)S or (R-Y)Ys(B-Y) [component input]
- (R-Y)Y(B-Y)3S or (R-Y)Y3s(B-Y) [component input]
(1)
Only available when the optional decoder + Limo Pro (R9828631) is installed.
OFF
ON
POWER MAINS
REMOTE
image 6.1
Inputfacilities
Which source to which input
This tabel (image 6.2) gives an overview of the relation between source type, input terminals and selection key on the RCU.
Port #
1
2
3
4/5
4/5
4/5
4/5
1 Input signal Y/C (luma/chroma)
2 Input signal : R, G and B with automatic sync detection between seperate sync (separate composite sync
or with separate hor and vert. sync) or sync on green (composite sync).
3 Input signal : R-Y, Y and B-Y with separate composite sync or with separate hor and vert. sync or with
composite sync on Y.
4 Input signal : R, G and B with separate tri level sync or with tri level sync on green.
5 Input signal : R-Y, Y and B-Y with separate tri level sync or with composite tri level sync.
* Video or S-Video : switchable in the picture tuning menu.
image 6.2
Input port, source type, RCU key table
5976397 SPLIT PACK REALITY 909 09112001
(1)
800 periphals
COMM. PORT
PORT 3
RS 232 OUT
IR
RS 232 IN
Projector input
Composite video (Optional)
1
S-video
/Composite video* (Optional)
2
RGB
2
RGB
3
Component video
RGB with tri level sync
Component video with tri level sync
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
R
G
B
Comp / H-Sync
V-Sync
PORT 4 / 5
4
(Optional)
5
(Optional)
Source connections
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
VIDEO
S - VIDEO
OFF - ON
75 Ohm
PORT 2
PORT 1
Press RCU digit buttons
1
2
3
4 or 5
6
7
8
OFF - ON
75 Ohm
green: operation
red: standby
PROJECTOR MODE
6 - 1

Advertisement

Table of Contents
loading

Table of Contents