4
INSTALLATION SETUP
Access to controls
Warning
RISK OF ELECTRIC SHOCK! TURN OFF THE PROJECTOR AND UNPLUG THE POWER CORD!
The installation should only be done by BARCO authorized service personnel.
Connecting optical block and electronic block together
Preparation to connect the cable tube
1
Loosen both indicated screws (image 4.1) on the back of the electronic block.
2
Remove the protection plate on the back.
3
Loosen both indicated screws (image 4.1) on the back of the optical block.
4
Remove the protection plate on the back.
5
Loosen the 4 indicated screws (image 4.1) on each side of the optical block.
6
Loosen the 3 indicated screws (image 4.1) on top of the optical block.
5
Remove the protection plate on the top.
Electronic block
image 4.1
Preparation connecting the cable tube
5976397 SPLIT PACK REALITY 909 09112001
Optical block
Installation setup
4 - 1