Ricoh Aficio 2035e Service Manual page 835

SP IFAX SW
1102 4 03
Bit 0: Original Output at Transfer Station
This setting determines whether the original is output at the transfer station when it is
received from the sender that initiated the transfer transmission. This feature is the
same as for G3 transfer transmissions.
0: Received original not output at the transfer station.
1: Received original output. The original is printed after the transfer station has
transferred it to the destinations, so its output confirms that the original has been
transferred.
Bit 1: Transfer Result Report
This setting determines when a Transfer Result Report is generated and returned to
the transfer requestor.
0: Returns the report after each transfer.
1: Returns the report only if an error occurred during transfer.
Bit 2: Destination Error Handling for Reception Transfer Request
This setting restricts transfer transmission based on whether the final destinations are
correct or not.
0: The transfer station transmits to correct destinations only (addresses with no
errors in them).
1: If any address has an error in it, the transfer station transfers no transmissions
and returns a transfer transmission failure report to the requestor that initiated the
transfer.
There is no negotiation between the transfer initiator and the transfer station to
determine whether the final destination addresses are correct or not. This setting
determines whether or not the transfer station transfers the transmissions if there is a
mistake in even one of the final destination addresses.
Bit 3: Polling ID Check for Reception of Transfer Request
This setting determines whether the polling IDs of incoming transmissions are
checked to ensure that the polling IDs match.
0: Receives and transfers only messages that have matching polling IDs.
1: Receives and transfers all messages, even if the polling IDs do not match.
Bits 4~7: Not Used
SP IFAX SW
1102 5 04
Bit 0: Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI
of the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI
or CSI is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the
Subject line that indicates where the transmission originated can be used to determine
automatically the destination folder for each e-mail.
Bits 1~7: Not Used
SM
SP1102 IFAX SWITCH
13 IFAX