Ricoh Aficio 2035e Service Manual page 446

ENERGY SAVER MODES
6.16.2 ENERGY SAVER MODE
Entering the energy saver mode
The machine enters energy saver mode when one of the following is done.
• The Clear Mode/Energy Saver Key is held down for a second.
• The energy saver timer runs out after the end of a job.
What happens in energy saver mode
When the machine enters energy saver mode, the fusing lamp drops to a certain
temperature, and the operation panel indicators are turned off except for the
Energy Saver LED and the Power LED.
If the CPU receives the image print out command from an application (e. g. to print
incoming fax data or to print data from a PC), the fusing temperature rises to print
the data.
Return to stand-by mode
If one of the following is done, the machine returns to stand-by mode:
• The Clear Mode/Energy Saver Mode key is pressed
• Any key on the operation panel or touch panel screen is pressed
• An original is placed in the ARDF
• The ARDF is lifted
• A sheet of paper is placed in the by-pass feed table
The recovery time from energy saver mode is about 3 s.
Operation
Mode
Switch
Energy
On
Saver
B135/B138
Energy
Fusing Temp.
Saver LED
B135: 130
On
B138: 150
6-102
+24V
o
C
On
o
C
System +5V
On
SM