Ricoh Aficio 2035e Service Manual page 246

SERVICE PROGRAM MODE
5131* Paper Size Type Selection
Selects the paper size (type) for both originals and copy paper. (Default depends
on DIP SW 101 setting.)
After changing the setting, turn the copier off and on. If the paper size of the
archive files stored on the HDD is different, abnormal copies could result.
5150* By-Pass Length Setting
Determines whether the transfer sheet from the by-pass tray is used or not.
Normally the paper length for sub scanning paper from the by-pass tray is limited
to 600 mm, but this can be extended with this SP to 1260 mm.
5162* Application Switching Method
Determines whether the application screen is switched with a hardware switch or
software switch.
0: Soft Key Set
1: Hard Key Set
5212* Page Numbering
Sets the horizontal and vertical starting points for the front and back sides of
duplex copies.
(–10 = Extreme top or extreme right, +10 = Extreme bottom or extreme left)
5212 3* Duplex Printout Right/Left Position
5212 4* Duplex Printout High/Low Position
5302* Set Time
Adjusts the RTC time setting for the local time zone.
Example: For Japan (+9 GMT), enter 540 (9 hours x 60 min.)
5404 User Code Count Clear
Clears the counts for the user codes assigned by the key operator to restrict the
use of the machine.
5501* PM Alarm
5501 1* PM Alarm Level
5501 2* Original Count
Alarm
B135/B138
0: Japan, 1: North America, 2: Europe
0: Off, 1: On
[–10~+10 / 0 / 1 mm step] DFU
[–10~+10 / 0 / 1 mm step] DFU
[–1440~+1440 / 1 min. step]
[0~9999 / 0 / 1 step]
0: Alarm off
1~9999: Alarm goes off when Value (1~9999)
0: No alarm sounds
1: Alarm sounds after the number of originals passing
through the ARDF ≥ 10,000
5-30
0: SW, 1: HW
≥
PM counter
SM