SERVICE PROGRAM MODE
1106
Fusing Temperature Display
1106 1
Roller Center
1106 2
Roller Ends
1106 3
I/O Board Temp.
at Power On
1109*
Fusing Nip Band Check
Checks the fusing nip band.
Paper Reverse Timing (Duplex)
1111*
Adjusts the timing for stopping the rotation of the reverse roller after the trailing
edge of the paper passes the duplex entrance sensor.
Adjust the timing if paper frequently jams at the inverter gate in the duplex unit.
1801*
Motor Speed Adjustment
Adjusts the speeds of the main motor, feed/development motor, and fusing exit
motor. Each step decreases or increases motor speed in 0.15% increments
1801 1
Main Motor
1801 2
Feed/Development Motor
1801 3
Fusing/Exit Motor
B135/B138
Displays the fusing temperature for the center of the hot roller.
Displays the fusing temperature for the ends of the hot roller.
Displays in the internal temperature of the machine when it
was powered on.
[0=Off, 1=On]
[+5 ~ –5 / 0 mm / 1 mm step]
[-4 ~ +4 / 0 / 0.15%]
[-4 ~ +4 / 0 / 0.15%]
[-4 ~ +4 / 0 / 0.15%]
5-8
SM