Ricoh Aficio 2035e Service Manual page 770

BIT SWITCHES
Communication Switch 0C
No FUNCTION
0 Number of digits compared to
to find the requester's fax number
4 from the programmed
Quick/Speed Dials when acting
as a Transfer Station
5-7 Not used
Communication Switch 0D
No FUNCTION
0 The available memory
to threshold, below which ringing
7 detection (and therefore
reception into memory) is
disabled
Communication Switch 0E
No FUNCTION
0 Minimum interval between
to automatic dialing attempts
7
B653
COMMENTS
00 - 1F (0 to 31 digits)
After the machine receives a transfer request, the
machine compares the own telephone number sent
from the Requesting Terminal with all Quick/Speed
Dials programmed in the machine, starting from
Quick Dial 01 to the end of the Speed Dials.
This number determines how many digits from the
end of the telephone numbers the machine
compares.
If it is set to 00, the machine will send the report to
the first Quick/Speed Dial that the machine
compared. If Quick Dial 01 is programmed, the
machine will send the report to Quick 01. If Quick
Dial 01 through 04 are not programmed and Quick
Dial 05 is programmed, the machine will send the
report to Quick 05.
Default setting - 05(H) = 5 digits
Do not change the settings.
COMMENTS
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
COMMENTS
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine
waits before it dials the next destination.
48
SP No. 1-104-013
SP No. 1-104-014
SP No. 1-104-015
SM