Main Parts; Controls; Rating Label; Installation - Vitrifrigo Trivalente Series User, Maintenance And Installation Manual

Always respect the indications (expiry date,
!
conservation, etc.) on the pack of the product
to be stored.
Any use other than those stated above is strictly prohibited.
The manufacturer refuses to accept any liability deriving
from improper use of the refrigerator.
The manufacturer reserves the right to take legal action
against those who modify the refrigerator without prior

Main Parts

written consent.
The refrigerator is composed as follows (see Fig.1):
A Door Panel
B Door Hinge
C Doorstop
D Control Panel
E Rating Label
F Bottle shelf
G Bottle Divider

Controls

The controls on the control panel "D" (Fig.1) are described here below (see
Fig.3):
1 - Fan on/off button
2 - Fan status indicator light
3 - Power source selection button
4 - Mains power indicator light
5 - Battery power indicator light
6 - Gas power indicator light
7 - Temperature selection button
8 - Selected temperature indicator
9 - Gas shut-off and adjustment knob + gas safety device
10 - Burner on indicator light

Rating Label

All information necessary for the clear and unequivocal identification of the
manufacturer, serial number, CE marking, and all technical characteristics
can be found on the rating label "E" (Fig.1) applied to the refrigerator (see
Fig.2).
1 Manufacturer
2 Model
3 Serial number
4 Climate class
5 Power supply voltages (V) - power consumption (W)
6 Type / Pressure GAS (mBar)
7 Rated power (W)
8 Gas consumption
H Shelf Guides
I Shelf
L Freezer
M Dissipater
N Drip Troy
O Defrost Water Drain System
P Connection Points

4. INSTALLATION

Warning

C11 type watertight equipment.This equipment must be installed in
accordance with the instructions in the instruction manual!Non-enclosed
type
A1 equipment.Use only in a well ventilated room, raised from the ground
and protected from rain.
Ensure that the packaging is undamaged. In the event of damaged
packaging, please inform the carrier.
Remove the packaging and proceed to the installation of the product.
This must be done with the utmost care and the use of protective gloves
to prevent accidental injuries to hands, is strongly recommended.
After unpacking the appliance, make sure that it is not damaged in any
way. Any damages must be communicated to the retailer no later than
24 hours from the date of purchase.
Read this chapter with care before proceeding to install the refrigerator.
Position the refrigerator on a flat, level surface and make sure that it is
not resting on the power cable (Fig. 4 A).
The refrigerator must be positioned away from heat sources if not
adequately protected (gas rings)(Fig. 4 A). Leave sufficient space to
ventilate the refrigerator (Fig. 4).
Before connecting the refrigerator, ensure that the power supply voltage
and the gas type and working pressure correspond to the data printed
on the appliance rating plate.
Make sure that the mains power earthing system is in perfect working
order (Fig.8).
Do not discard the appliance packaging. This material must be sorted
and disposed of according to the local standards in force with regard to
waste disposal.
Connect the battery voltage supply cable to the vehicle system, taking
care to respect polarity. Polarity inversion will cause damage to the
electronic control unit.
Do not install the refrigerator where the vehicle door, when opened, will
obstruct the ventilation grid.
12