Topcon GTS-600 Series Instruction Manual page 59

Erase a Block of Points or Erase One Point
A block of point numbers can be erased within a job. To erase a block of points, the record numbers
representing the points are entered. After typing in the block of record numbers, press the (ENT) key.
The software will prompt the user to answer the question (YES) or (NO) to erase the record number. If
(YES) is selected, the block of record numbers (points) will be erased. If (NO) is selected, the message
(Cancel) will appear on the display for a few seconds and the Job Manager menu will appear.
Another option in Job Manager is to erase one point This routine works the same as erasing a block of
points, but only one record is erased at a time.
Follow the examples below to erase a block of points and to erase one point.
Erase a Block of points
Operating procedure
1
At the Job Manager menu press [F2] Erase
One Points.
2
The next screen allows the user to type in the
record number. Press (ENT) after typing the
record number. If a wrong number is typed in,
press [F6] to back space.To Exit, Press [F1].
3
The next screen allows the user to continue
erasing the record or to cancel the routine
without erasing the record. Press [F5] to
erase the record or [F6] not to erase the
record. Pressing [F6] will cancel the routine
and return back to the Job Manager menu.
Erase One Point
Operating procedure
1
At the Job Manager menu press [F3] Erase
One Points.
2
The next screen allows the input the of record
numbers to erase. Press (ENT) after typing
each record number. If a wrong number is
typed in, press [F6] to back space.To exit this
routine, Press [F1].
3
The next screen allows the user to continue
erasing the block of records or to cancel the
routine without erasing. Press [F5] to erase
the record or [F6] not to erase the record.
Pressing [F6] will cancel the routine and
return back to the Job Manager menu.
Operation
Job Manager (Pg 1/2)
F1 View Memory
F2 Erase a Block of Point
F3 Erase One Point
F4 Create Another Job
[F2] Erase a Block of Point
REC #
EXIT
[ENT] Erase a Block of Point
[F6]
Erase OK?
OR
[F1]
[F5]
OR
[F6]
Operation
Job Manager (Pg 1/2)
F1 View Memory
F2 Erase a Block of Point
F3 Erase One Point
[F3]
F4 Create Another Job
Erase One Point
REC #
[ENT]
EXIT
[F6]
OR
[F1]
Erase One Point
REC # [001]
[F5]
Erase OK?
OR
[F6]
4-15
4 PROGRAM MODE
Display
↓
-
REC # [001-009]
YES NO
Display
↓
BS
YES NO
BS