Retaining A Coordinate (Store- Nez) - Topcon GTS-600 Series Instruction Manual

4.2 Retaining a Coordinate (STORE- NEZ)

In this program the coordinates for the next point are stored in memory after the measurement is
complete and accepted. This feature allows the user to occupy the next move up point and use the
previous occupied point for the backsight orientation.
When occupying the next point and backsighting the original occupied point, the instrument will display
the reciprocal angle for backsight orientation. If the occupied coordinates are not preset, zero (0,0,0) or
the previous preset coordinates will be used for this program.
N
Origin (0,0,0)
Set the the coordinate value of instrument point P
P0 toward known point A
Operating procedure
1
Press [F2](STORE) key.
2
Press [F1](Store NEZ) key. *1)
3
Collimate target P1 prism which the
instrument moves.
4
Press [F1](MEAS) key.
Measuring will start.
Horizontal distance and horizontal angle are
shown.
Known point A
Direction angle
P
1
P
2
Inst. point P
0
and set the direction angle from instrument point
0
Operation
Programs
F1 BS
F2 STORE
F3 REM
F4 MLM
[F2] Retaining Coordinate
1.Store NEZ
2.Recall NEZ
[F1] Store NEZ
HR :
HD :
MEAS
Collimate
P1
[F1] Store NEZ
HR :
HD *
MEAS
Store NEZ
HR :
HD *
MEAS
4-3
4 PROGRAM MODE
P
3
E
Display
p 4/8
p
p
p MORE
120°30'40"
m
HT SET
100°10'20"
<
m
SET
100°10'20"
123.456 m
SET