Coordinate Measurement; Setting Coordinate Values Of Occupied Point - Topcon GTS-600 Series Instruction Manual

3.3 COORDINATE MEASUREMENT

3.3.1 Setting Coordinate Values of Occupied Point

Set the coordinates of instrument (occupied point) according to coordinate origin, and the instrument
automatically converts and displays the unknown point (prism point) coordinates following the origine.
It is possible to retain the coordinates of the occupied point after turning the power off (Resume mode
:OFF). Refer to Chapter 7 "PARAMETERS SETTING MODE" .
Origin(0,0,0)
Confirm the angle measurement mode.
Operating procedure
1
Press [F3](NEZ) key.
2
press [F6]( ) key to get the function as on
↓
page 2.
3
Press [F5](SET) key.
The previous data will be shown.
N
n
Inst.PointC
Operation
3-9
3 STANDARD MEASUREMENT MODE
Prism (n,e,z)
z
E
e
V : 90°10'20"
HR: 120°30'40"
SD HD NEZ
[F3]
N :
E :
Z :
MEAS MODE
[F6]
REC HT MEAN
[F5]
Setting occ. point
N : 12345.6700
E :
Z :
EXIT
Display
0SET HOLD P1
↓
<
PSM 0.0
PPM 0.0
(m) *F.R
VH SD HD P1 ↓
m/ft SET P2
↓
12.3400
10.2300
BS