Operate Instruments With The Foot Control - KaVo ESTETICA E70 Vision Short Instructions For Use

Short instructions for use 5 Operate instruments with the foot control

5 Operate instruments with the foot control

▶ With the handpieces stored, press the foot pedal.
ð The type of treatment advances upon each actuation of the foot pedal.
▶ Hold down the foot pedal and press the stirrup switch (with handpieces
stored).
ð Up to six users can be programmed. This can be set in "User" in the
"Settings" tab.
▶ Take the handpiece (e.g., turbine, motor, PiezoLED, etc.) from the
holder.
ð The handpiece is active.
▶ Press the footpedal.
ð The removed instrument runs at the set speed or intensity.
▶ Changing speed or intensity with the foot pedal.
ð The left stop corresponds to the minimum speed/intensity.
ð The right stop corresponds to the maximum speed/intensity.
Preselect counterclockwise motor rotation
▶ Take motor from the holder.
ð The handpiece is active.
▶ Slide the cross switch upward.
ð The direction of motor rotation is reversed each time the cross-switch is
actuated: counterclockwise rotation - clockwise rotation.
ð The direction of motor rotation is displayed on the dentist element.
Pre-selecting the cooling status
▶ Remove the handpiece (such as turbine, motor) from the holder
ð The handpiece is active.
▶ Press "Preselected spray" footswitch.
ð The cooling level is raised each time the footswitch is pressed: no cool-
ing - air - spray.
ð The cooling level is displayed on the dentist's and assistant's element.
▶ Remove the handpiece (such as turbine, motor) from the holder
ð The handpiece is active.
27