Wiring - Simplex 4098 Applications Manual

4098 TrueAlarm QuickConnect SMOKE SENSORS,

Wiring

Notes:
1. Remote LED and relay wires are not
supervised.
2. Maximum quantity of devices per circuit
is 127 for 4020, 4100+, or 4120 panels
and 250 for the 4010 panel. Maximum
quantity of 4098-9713 sensors when
output is coded (Temporal Code) is 43.
3. If shield is used, twist shield wires
together and cap with wire nut. Shield
should be insulated from electrical box.
4. Contact A or B: Dry, Form C - each rated
2 amperes at 28 VDC/0.5 amperes at 110
VAC, resistive.
5. 18 to 32 VDC, .008 amperes typical/.013
amperes max.
6. When using the 4098-9822 relay module,
DO NOT use remote LED.
7. 4098-9710 and 4098-9757 are ONLY
compatible with 4010 FACP.
8. 4098-9757 QuickConnect sensor uses the
4098-9788 base.
Use the following to wire the QuickConnect smoke sensors.
Caution: Do not loop wire under terminals. Break wire runs to provide supervision.
FROM
PANEL
(IF USED)
4098-9710
(SEE NOTE 7)
-IDNet
FROM
PANEL
+IDNet
SHIELD IS OPTIONAL SHIELD
(SEE NOTE 3)
+24V +24V
FROM
PANEL
(IF USED)
0V 0V
4098-9713
-MAPNET II/IDNet
FROM
MAPNET/IDNet
PANEL
+MAPNET II/IDNet (SEE NOTE 2)
SHIELD IS OPTIONAL
SHIELD
(SEE NOTE 3)
4098-9710 TERMINAL STRIP
Figure 19. QuickConnect Sensor Connections
firealarmresources.com
Continued
+24V
0V
4098-9788
(SEE NOTES
8 & 7)
4098-9713
SHIELD
SHIELD
+24V
FROM
TO OTHER
PANEL
24V DEVICES
(IF USED)
0V
4098-9713
2098-9808
REMOTE LED
ALARM
(SEE NOTE 1)
TO OTHER -MAPNET II/IDNet
FROM
PANEL
DEVICES
+MAPNET II/IDNet
SHIELD
4098-9713 TERMINAL STRIP
37
+24V
TO OTHER
24V DEVICES
0V
2098-9808 REMOTE LED
OR 4098-9822 RELAY
(SEE NOTE 1)
-IDNet
TO OTHER IDNet
DEVICES
(SEE NOTE 2)
+IDNet
+24V
TO OTHER
24V DEVICES
0V
(SEE NOTE 5)
RED ORG (C)
RED 4098-9822 YEL (NC)
(SEE NOTE 4)
BLK RELAY GRN (NO)
BLK MODULE BRN (C)
(SEE NOTE 6)
WHT VIO (NC)
(SEE NOTE 4)
BLU GRY (NO)
(SEE NOTE 6)
TO OTHER
-MAPNET II/IDNet
MAPNET/IDNet
DEVICES
(SEE NOTE 2)
+MAPNET II/IDNet
CONTACT A
CONTACT B