Remote Led Module - Simplex 4098 Applications Manual

ACCESSORIES, Continued
Relay Modules (continued)

Remote LED Module

Installation
Install the relay module using the following steps:
1. Mount a 1-1/2 inch (3.81 cm) extension ring (not supplied) to an octagonal
or square electrical box (not supplied). The extension ring is required to
meet the minimum box volume requirement (32.3 cu. inch/529.4 cu. cm) for
relay module installation.
2. Mount relay module inside extension ring directly behind base and sensor.
Do not mount remotely. See Figure 20 or 21 for relay module connections.
Note: Use the exact configuration of electrical box (square or octagonal) with
extension to mount sensor base when installing the relay module.
The 2098-9808 Remote LED Module is available for the 4098-9789 ,-9791, -9794,
-9795, -9796 Sensor Bases and the 4098-9713 QuickConnect Sensor with Sounder.
Use Figure 22 as a reference when installing the Remote LED Module to a
sensor base.
RED BLACK
2098-9808
LED
Figure 22. 2098-9808 Remote LED Module Wiring
40
firealarmresources.com
To 4098-9789, -9791, -
9794, -9795, -9796 Sensor
Base or 4098-9713
QuickConnect Sensor with
Sounder