Multi-Sensor Bases 4098-9795 And 4098-9796; Wiring - Simplex 4098 Applications Manual

4098 TrueAlarm SENSOR BASES, Continued
Multi-Sensor Bases 4098-9795
and 4098-9796
SEE
NOTE 1
RESERVED FOR
FUTURE USE
DIP
SWITCHES
1 THRU 4
Note: The 4098-9795 Multi-Sensor Sounder Base has a 9-position DIP switch that is used for setting
base address and selecting the sounder power source. See Figure 10 for DIP switch location.
Figure 14. 4098-9795, -9796 Multi-Sensor Base DIP Switch Address Settings

Wiring

The Multi-Sensor Bases 4098-9795 and -9796 are only for use with the
4098-9754 multi-sensor and are not compatible with the 2120 CDT. Both bases
have remote LED output and the 4098-9795 also has an integrated sounder
similar to the 4098-9794 Sounder Base.
The Multi-Sensor Base answers to two addresses, therefore the DIP switch must
be set for even addresses only. The even address is a photo sensor/sounder base
(4098-9795) or a photo sensor/standard base (4098-9796), and the odd address
(DIP switch + 1) is a heat sensor/standard base. Figure 14 shows the allowable
addresses for the Multi-Sensor Bases.
Important: Switch position 1 is not used and must always be OFF (0) for the
Multi-Sensor Bases to function properly. The odd address
immediately after the DIP switch setting must not be used by any
other sensor base or MAPNET/IDNet device.
LSB MSB
1 2 3 4 5 6 7 8 9
ON
OFF
SEE
NOTE
0000 1000 0100 1100 0010 1010 0110 1110 0001 1001 0101 1101 0011 1011 0111 1111
0000 0 16 32 48
0100 2 18 34 50
0010 4 20 36 52
6 22 38 54
0110
8 24 40 56
0001
0101 10 26 42 58
0011 12 28 44 60
0111 14 30 46 62
SWITCH 1 MUST BE SET TO OFF
FOR PROPER OPERATION
Sensor bases are connected to the fire alarm control panel via a single wire pair
for the 4098-9789, -9792, -9793, and -9796, and two pairs of wires for the 4098-
9791, -9794, and -9795. Using Figure 15 as a reference, connect the bases to the
MAPNET II/IDNet wire pair and 24V power (if used).
Important: For additions to existing installations, remove power from the panel
before wiring any bases to avoid damage to equipment.
firealarmresources.com
DIPSWITCH IS SHOWN
SET AT ADDRESS 4.
1 = ON 0 = OFF
DIP SWITCHES 5 THRU 8
64 80 96 112 128 144
66 82 98 114 130 146
68 84 100 116 132 148
70 86 102 118 134 150
72 88 104 120 136 152
74 90 106 122 138 154
76 92 108 124 140 156
78 94 110 126 142 158
RESERVED FOR FUTURE USE
31
160 176 192 208 224 240
162 178 194 210 226 242
164 180 196 212 228 244
166 182 198 214 230 246
168 184 200 216 232 248
170 186 202 218 234 250
172 188 204 220 236 252
174 190 206 222 238 254
Continued on next page