Table of Contents
Advertisement
U3025AE10
Controlling the System with E8363/4C and N5230C
Sweep Setup for Multiport and Standalone PNA Modes
When the Test Set is connected to the PNA, it is recommended that the analyzer's Sweep
Setup be configured to Stepped Sweep before calibrating. This is slower than the Analog
Sweep, but is more accurate due to the extra electrical length of the Test Set and test port
cables. Only Stepped Sweep is available on all PNA models.
1. On the PNA select STIMULAS > Sweep > Sweep Setup.
2. Select Stepped Sweep.
3. Set the Dwell Time to 5 μs > OK.
Figure 24
ECal Characterization
24
User's Guide U3025-90001
This Manual:http://www.manuallib.com/agilent/u3025ae10-test-set-user-guide.html
Advertisement
Table of Contents
