Table of Contents
Advertisement
U3025AE10
System Setup E8363C, E8364C or N5230C
WARNING
Preparing the PNA Network Analyzer
1. Remove the feet from the bottom of the network analyzer. Refer to
2. Remove the 2 lower standoffs and screws (0515-1619) from the rear panel on the
network analyzer.
Figure 6
3. Install the two rear locking feet (5023-0132) using the included screws (0515-1619),
where the standoffs were removed.
Figure 7
Screws (0515-1619)
Included in package
User's Guide U3025-90001
This Manual:http://www.manuallib.com/agilent/u3025ae10-test-set-user-guide.html
The opening of covers or removal of parts is likely to expose the user
to dangerous voltages. Disconnect the instrument from all voltage
sources while it is being opened.
Rear Bottom Feet
Standoffs (x2)
Feet (x4)
Install Locking Feet
System Setup E8363C, E8364C or N5230C
Figure
6.
Locking Feet
(5023-0132)
13
Advertisement
Table of Contents
