Table of Contents
Advertisement
U3025AE10
4. Place the network analyzer on top of the Test Set and ensure that the front frame of the
network analyzer is positioned slightly forward of the locks that are attached to the Test
Set. Slide the network analyzer back so the locks engage the front frame of the analyzer.
Figure 8
5. Secure the network analyzer's lower locking feet to the Test Set upper locking feet,
using the spring–loaded screws on the locking feet. Refer to
analyzer's lower locking feet are not aligned with the screw holes in the Test Set's upper
locking feet, loosen the screws securing the feet to the instrument slightly to align.
Figure 9
NOTE
14
This Manual:http://www.manuallib.com/agilent/u3025ae10-test-set-user-guide.html
Locking the Analyzer's
Lock Link
Locking Feet Screws
There are two Lock-Feet kits available. Refer to
page 48
for ordering information.
• PNA − 5023-0132 (Kit includes locking feet and screws)
• Test Set − 5063-9253 (Kit includes lock links, locking feet and screws)
System Setup E8363C, E8364C or N5230C
Network Analyzer
Front Frame
Slide the network Analyzer
screw
back to engage the lock link
in the back of the network
analyzer's front frame
Test Set
Front Frame
Figure
9. If the network
"Contacting Agilent" on
User's Guide U3025-90001
Advertisement
Table of Contents
