Communication with a control system
10.2 Test process sequence over time
a.) Saving curves and results without loss of data
If you opt for the "no data loss" storage method and want to save curves and/or
results on the memory card or externally via bus, the diagram in Fig. 10.1 on
page 94 applies.
The Ready signal only returns to 1 when
S the process is completely finished,
S all the data has been saved in its entirety, and
S the device is ready to save the data for the next process.
Important
If the process data (curves and results) cannot be saved (e.g. because the
memory is full or faulty), the next process cannot be started, as the MP85A
process controller does not enable the Ready signal.
When backing up data to a PC (external storage), the PME Assistant or
INDUSTRYmonitor must remain open.
MP85A
93
A0293_06_E00_03 HBM: public