Hardware Setup; Power Supply/Transducers - HBM MP85A Series Operating Manual

Starting up/Setup mode
ADDITIONAL FUNCTION
7.2

Hardware setup

7.2.1

Power supply/transducers

► Connect the power supply cable and transducers to the module as
described in section 5.
► Switch on the power supply.
► The device performs a function test (approx. 10 s) and then, if this is suc­
cessful, goes into measuring mode. During the self-test, the control out­
puts stay at 0 V.
If ! appears on the display or the status LED glows red, an error has
occurred. Please see section 12 "Error messages", on page 107.
62
AmplType Save?
PrgVers
SrNo
Measured value
HW vers
MMC/SD
Lo(ad)
Back
Main GRP
A0293_06_E00_03 HBM: public
Groups
MEAS. MODE
± ° Yes
No
± °
0...31
SYSTEM STATE
S-Status
Save
S-Status
Restore
S-Status
Load-Com
Back
Main GRP
MP85A