Installing The Pme Assistant Software - HBM MP85A Series Operating Manual

Starting up/Setup mode
7.3

Installing the PME Assistant software

Install the PME Assistant using the supplied system CD. You can also find the
latest version on the HBM website:
Support -> Downloads -> Firmware & Software.
System requirements
To run the PME Assistant software, you need a PC that meets the following
requirements:
S Intel Pentium 2 GHz processor or equivalent
®
S Windows
XP or higher
S Microsoft Internet Explorer 7.0 (or higher)
S Main memory (RAM)
- 512 MB for Windows
- 2 GB from Windows Vistat
- 3 GB from Windows
S Graphics card with resolution of at least 1024 x 768 pixels
S 20 MB of free memory on your hard disk
The NTFS file system is required if you are recording numerous processes
and more than 65,000 files may be generated on the PC during a test.
S Microsoft or 100% compatible mouse
S Installed standard printer
S Interface: Ethernet or USB CAN interface from PEAK
S The following fonts must be installed: Arial (TT), Courier, MS Sans Serif,
Small Fonts, Tahoma, Times New Roman (TT), Verdana and Wingdings.
The fonts are normally installed with Windows
64
www.hbm.com/download
®
XP
®
10
A0293_06_E00_03 HBM: public
-> Services &
®
.
MP85A