Installing/Removing The Mp85A (Schematic Diagrams); Mechanical Installation/Removal - HBM MP85A Series Operating Manual

Installing/removing the MP85A (schematic diagrams)

4 Installing/removing the MP85A (schematic
diagrams)
The device must be mounted on a support rail to DIN EN 60715, which is
connected to a grounded conductor. Both the support rail and the device must
be free of paint, varnish and dirt at the mounting location.
Important
Automation equipment and devices must be designed so as to ensure
adequate protection or locking against unintentional actuation (e.g. access
control, password protection, etc.).
Protect the device from direct contact with water. The IP rating is IP20.
4.1

Mechanical installation/removal

Fig. 4.1 Installation on a support rail
18
A0293_06_E00_03 HBM: public
MP85A