Table of Contents
Advertisement
(2) Cleaning of Belt
Wash soiled belts with soap and water. The water temperature must not exceed +60 ºC (+140 ºF).
10.3 Disinfecting
Clean the equipment before disinfecting.
The table below lists the allowed disinfectant bases:
Type
Transducers
1 Do not use any disinfectant containing additional active ingredients other than those
listed.
2 Follow the manufacturer's instruction to dilute the solution, or adopt the lowest
possible density.
3 Do not immerse any part of the monitor or any accessory into liquid.
4 After disinfection, confirm there is no remaining disinfectant on the surface.
5 Check that the monitor and accessories are in good condition. If any aging or damage
is detected (e.g. the belt loses its elasticity), replace the damaged part(s) or contact
Wallach Surgical Devices for service before reusing them.
10.4 Sterilizing
Do not sterilize the monitor or the accessories, unless this is necessary according to your hospital
regulation.
Chapter 10: Maintenance and Cleaning
Ethylate
Acetaldehyde
√
√
CAUTION
- 59 -
Recommended
Ethanol 70%
Isopropanol 70%
Advertisement
Table of Contents
