Table of Contents
Advertisement
8.2.1 Changing Time Scale
The fetal monitoring traces share the same time scale, which displays the time every two minutes.
This scale is either in real time format or relative time format. Real time is the time of the monitor.
Relative time records the elapsed time for the current monitoring.
To change this time format:
1. Select the setup key
2. Select Date And Time > Time Scale.
3. Select Real Time (default) or Relative Time.
4. Select OK.
NOTE:
The real time contains only the hour and minute, but not seconds. Do not mistake the time scale
for the exact time.
8.2.2 Searching for a Patient's Record
The auto-saved data of every monitoring is stored as a separate file in the monitor. With the
searching key
, you are able to find a patient's monitoring record easily.
1. Select the search key
which records a list of up to 50 most recent patients' ID and name (When the USB feature
is disabled, the interface is shown as follows).
2. If the required record is not on the current page, select Next to view more records.
3. Move the cursor to select the required item (if the USB feature is enabled, you should
select Load in the pop-up item), and the monitor loads the traces of this record to the
main interface for review.
Chapter 8: Understanding Measurement Results
on the main interface.
on the main interface to open the Patient Searching interface,
Figure 8-5 Patient Searching
- 48 -
Advertisement
Table of Contents
