Chapter 3: Installation Guide
3.6 Connecting Transducers
Check for visible damage to the transducers every time before connecting them to the monitor.
Pay special attention to possible cracks on the transducers and cables before immersing them into
conductive fluid. If damage is found, replace them.
When plugging transducers into the monitor, make sure the arrow symbol of the connector is
facing up.
Connecting the transducer
Disconnecting the transducer
When disconnecting a transducer, pinch the body of the transducer plug and pull it out gently.
NOTE:
Never try to disconnect the transducer by pulling the cable directly.
3.7 Placing Accessories in the Holder
In order to protect the accessories, place the not-in-use accessories in the holder. The accessory
holder is on the left of the front panel. The first hole from the top is for the remote event marker,
and the other three are for the transducers.
To place a transducer into the holder, hold the transducer on the edge, and then place the buckle
- 24 -