Table of Contents
Advertisement
The recorder plate, thermal print head and paper sensing mechanism must be cleaned at least
once a year or when needed (when trace becomes faint). The following procedure may be used:
1. Switch off the monitor and open the paper drawer.
2. Wipe the printhead with a cotton swab or a soft cloth moistened with isopropyl alcohol.
3. Air-dry the printhead surface and then close the drawer.
Use only paper provided by Wallach Surgical Devices or damage to the recorder may
occur. This type of damage is not covered by warranty.
10.2 Cleaning
In order to avoid contamination, clean and disinfect the monitor and accessories after each use.
10.2.1 Cleaning of the Monitor
1 Unplug the monitor from the AC power source, remove the battery and detach all
accessories before cleaning.
2 Do not immerse the unit in water or allow liquids to enter the case. If liquid is splashed
on or into the main unit inadvertently, or enters the conduit, stop using the monitor
and contact the manufacturer for service immediately.
Regular cleaning of the monitor enclosure and the screen is strongly recommended.
The solutions recommended for monitor cleaning are: mild soapy water, Tensides, Ethylate and
Acetaldehyde.
Chapter 10: Maintenance and Cleaning
CAUTION
WARNING
- 57 -
Advertisement
Table of Contents
