Table of Contents
Advertisement
5.2.1 Switching Auto Start Printing On or Off
Switch auto start printing on or off as follows:
1. Select the setup key
2. Select Start Monitoring > PRINT.
3. Select ON or OFF (default).
4. Select OK.
5.2.2 Choosing Paper Speed
Paper speed choices are 1 cm/min, 2cm/min or 3cm/min:
1. Select the setup key
2. Select Recorder > Print Speed.
3. Select 1 cm/min, 2 cm/min or 3 cm/min (default).
4. Select OK.
NOTE:
Different paper speed setting causes different FHR trace appearances on the record paper. To
avoid misinterpretation, we recommend you to set all monitors in use to the same paper speed.
5.2.3 Changing Print Timer
Different time lengths can be chosen for the print timer:
1. Select the setup key
2. Select Recorder > Timer.
3. Set timer to 10 ~ 90 (minutes, the increment is 5) Present ID or Infinite.
For a fixed time, the recorder stops when the time is up.
For Present ID and Infinite, the recorder will only print the traces of the patient with the
present ID, and stops automatically when her traces come to an end. If there is no ID on
the current reviewing screen, the recorder with Present ID setting starts printing from the
beginning of this ID, and with a fixed timing or Infinite setting, it starts printing from the
left border of the screen. Whatever the setting is, the recorder stops when the PRINT key
is pressed in midway.
4. Select OK.
on the main interface.
on the main interface.
on the main interface.
- 31 -
Chapter 5: Printing
Advertisement
Table of Contents
