Segway FUGLEMAN UT10 2022 Owner's Manual page 98

OPERATION OPERATION
rope.
• When using the winch to move the load, place the vehicles
transmission in neutral and apply the brake of the vehicle
and place wedges under each wheel. When the hoist is
working, the vehicle engine should be operated to charge the
battery. Never use the winch with insufficient voltage.
• Never disconnect the power supply when there is a load on
the winch.
• After the operation, release the load immediately and do not
tighten the rope.
• Always stay away from ropes, hooks and winches when in
operation or under load.
• Check winches, ropes, hooks, and broken strands of worn
rope regularly. When handling the rope, please wear thick
leather gloves. Do not let the rope slip over your hands.
Check the rope before use.
• Crushed, pinched, worn or kinked areas seriously reduce the
carrying capacity. A damaged rope should be replaced. It
must be re-wound under a load of about 100 pounds.
• The clutch should be disconnected first, and then the rope
should be pulled by the hook of the protective lever. Do not
pull the rope directly through the hook with your fingers.
• Maintain the specified tension so that the rope can be wound
on the reel and re-rolled after the operation tight.
• Do not operate the winch under the influence of alcohol or
drugs. Be cautious during operation. If there is a problem,
you should cut off the battery immediately and check it
carefully.
• Wear goggles, insulating overalls, non-slip shoes, work caps,
thick leather gloves, Place long hair tightly under a work cap
and remove all jewelry.
90